Shipping Weight: 1 poundsShipping Special
Keep your headlights looking their best for the long haul. These durable, UV-resistant guards help prevent damage caused by rocks, road debris, salt and oxidation, all of which reduce brightness and overall effectiveness of your Ford F-250 and F-350 Super Duty's lights.
Note: The glowing outlines in the image above show how the included headlight guards are formed and where they will install on your Ford F-250 and F-350 Super Duty's headlamp assemblies. The headlights on your Ford F-250 and F-350 Super Duty should resemble those pictured above.
Every day your headlights face the damaging effects of rocks, sand, dirt and road debris. In the winter, they may take a beating from salt-laden slush. And all day long, they suffer from exposure to harsh UV rays. With Husky Shield headlight guards, this damage can be a thing of the past. The impact-resistant urethane material is thin and flexible enough to glide easily onto your Ford F-250 and F-350 Super Duty's headlights, yet it is thick and durable enough to withstand rocks and flying debris. The film also has UV inhibitors that minimize the oxidation caused by sunlight, preventing yellowing of the lenses.
Note: It is recommended that you apply Husky Shield headlight guards after polishing your lenses. Most polishing kits on the market work to remove damage, but they also remove the thin, hard-coat protective layer that sits atop acrylic and polycarbonate lenses. Applying this urethane film over just-polished headlights will seal the lenses while they look their best and prevent future damage by creating an impact- and UV-resistant barrier.
After thoroughly cleaning your headlight lenses, apply the included solution to one of the lenses, to your hands and to the film itself. This solution not only lets you easily position the guards on your lights, but it also keeps the film free from fingerprints and other contaminants. The film must remain wet throughout the installation process to ensure proper placement.
Once you have the protector in place on the headlight lens, set the film by squeegeeing out the solution. Make sure that the outside of the film remains saturated during this process so that the included application card can slide smoothly along its surface. If you are not happy with the position of the film, gently peel it back while wetting the adhesive side with additional solution, and reset.
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time.