Easily attach a variety of accessories to the front of your Chevrolet Silverado with this fully welded, corrosion-resistant trailer hitch receiver. Perfect for winches, spare tire carriers and more.
At etrailer.com we're committed to the products we sell, and to our customers. Our experienced and knowledgeable staff are available via both phone and email to address your questions and concerns for the lifetime of your hitch. The technicians at etrailer perform hitch installations on a daily basis, making them a valuable resource for do-it-yourselfers. The one-on-one, personal service you'll receive comes straight from an expert in the towing and automotive field. We've installed it, we've wired it and we've towed with it, so whatever your question, we can answer it.
Average Customer Rating: 4.7 out of 5 stars (7 Customer Reviews)
by: Ray G.11/19/2012
I like the new front hitch for my Silverado, especially receiving it so quickly after ordering. I truly did not expect it to arrive so quickly. And, the shipping container was undamaged, another plus. The hitch itself is quite good, and probably is easier to install than most, being in three pieces, to bolt together when in place on the truck. It certainly looks strong enough, but there was a little non-alignment with the attachment holes in the truck. Everything went together eventually, and I did it without a friend's help.59708
good communication fast delivery very pleased with product. this hitch was installed on a 2011 gmc sierra 1500.i removed the lower air dam and did not replaced it.had to remove shield 4 bolts to gain access to larger hole in cross member.following steps 1-4 was a normal installation. 33031
by: Jeff B.10/04/2011
Fit between the mounting brackets on my 2008 GMC Sierra 1500 4x4 was a little tight but it bolted up just fine. Looks very well made. I removed the lower front air dam ( I didn't like it anyway) & it fit perfectly underneath the bumper & license plate mount. Will be using the front hitch skid shield with this.25074
by: Bryan S.02/17/2011
I am a "Do It Yourselfer", this hitch took me about 90 minutes total to install on my 2011 GMC Sierra. It is a good quality product. It shipped as advertised, and fit. The small 2 1/2 " square cut at the bottom of the fender skirt is very low profile and I covered it completely with a decorative insert. I recomend this product for anyone that has a tight spot or corner to get their trailer into or around.7364
Very stout hitch with nice, thick paint job. Will do the job very well. The only thing I'd change about the hitch is how far back the receiver is. It's slightly UNDER the bumper, so I had to find my longest drawbar to make the ball clear the front of the truck. I'd rather it stuck out several inches farther forward. I also needed two deep-set sockets to get this install done: a 21mm and an 18mm. Regular sockets were not deep enough to go over the bolts to get to the nuts. I'd also recommend having a breaker bar handy. The factory torqued a couple of bolts down incredibly tight. Because of this the install took me a couple of hours, not the 60 minutes the instructions said. 70080
Good service, fit real well, 1 hour in stallation86780
by: Craig Rubinic04/06/2012
very fast shipment , looks very nice , very nice coating,would order other thing when needed thank you Craig36323
Ask the Experts about this Curt Front Hitch
Do you have a question about this Front Hitch?
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time.Let us know if anything is missing or if you have any questions.