Curt Custom Fit Vehicle Wiring for the 2009 Ford Flex

Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector - 2009 Ford Flex

Quickly and easily install a 4-way trailer connector on your Ford Flex with this custom harness. T-connector plugs directly into existing wiring. Powered converter reduces strain on wiring system and is made using SMT to ensure superior performance.

Features:

• Provides a 4-way flat trailer connector at the back of your Ford Flex to power your trailer's signal lights
  • Compatible with 5-pole, 6-pole and 7-pole adapters (sold separately)
• Connects quickly and easily
  • Locate connection points behind tail lights
  • Plug in T-connector
  • Run hot lead to car battery
• Includes powered tail light converter that connects directly to battery to avoid overloading Ford Flex's electrical system
• Constructed using surface-mount technology (SMT) for consistent, reliable performance
  • Maximizes trailer light yield and intensity while producing minimal heat
  • Ensures superior operation in rough road conditions
• Comes with dust cap for 4-way flat connector
• Made in the USA

Specs:

• Maximum amperage:
  • Stop/turn lights: 3 amps per circuit
  • Tail lights: 6 amps per circuit
• Limited 1-year warranty

Installation

This custom-fit T-connector plugs into your Ford Flex's wiring harness, which is located behind the driver's-side and passenger's-side tail lights. You will have to remove the tail light assemblies to access this harness. Once you've plugged in the T-connector, run the hot lead up to your car battery. Connect the lead to the included fuse holder, and then connect the fuse holder to the positive terminal on your battery.

Once installation is complete, the 4-way connector will be stowed beneath your Ford Flex, near the trailer hitch. A mounting bracket (sold separately) is recommended to keep the connector secure.

It is recommended that you use a small amount of grease on all electrical connections - the plugs on your automobile and the 4-pole connector itself - to help prevent corrosion.

Powered Tail Light Converter with Surface-Mount Technology

A tail light converter is built into this T-connector. This converter is a circuit-protected, battery-powered unit that bypasses the electrical routes that are used by a basic wiring harness. As a result, there is virtually no draw on your tail light circuits.

Curt builds each tail light converter using surface-mount technology (SMT). This method of construction involves soldering electronic components directly to the surface of a printed circuit board. SMT eliminates the need for leads, which are used in older through-hole technology. The result is a circuit board that is smaller yet provides more routing area and that offers superior performance, reliability and durability.

Circuit boards constructed using SMT have been shown to perform better under rough conditions with excessive vibration than those made using the through-hole method. And where would vibration be more likely to occur than in towing applications? Curt converters also produce less heat, leading to increased durability and longer life. In addition, lower levels of resistance ensure better performance, especially for parts that operate at higher frequencies.

Each Curt circuit board is made using high-quality components that are pieced together in the most technologically savvy fashion, leading to greater predictability and reliability in functioning.

56063 CURT T-Connector - Surface Mount Technology - 4 Wire

Ask the Experts about this Curt Custom Fit Vehicle Wiring

Do you have a question about this Custom Fit Vehicle Wiring?