Ease installation of your electric brake controller by using this custom wiring adapter. Simply connect the 4 wires of the harness to your brake controller and then plug the other end into the port in the center of your vehicle's dash.
Features:
This adapter plugs into the connector beneath your vehicle's dashboard. To reach the connector, remove the storage pocket that is built into the center of your dash, just above the ashtray. Once you have removed the pocket, you will see the gray, 4-pin connector that mates with the adaptor.
To install your electric brake controller you need to connect the four wires - ground, power, brake switch and brake power - of the controller to your vehicle. Certain manufacturers offer pre-wired options, typically known as tow packages, wherein these wires are run for you from the dash to the trailer connector on the back of your vehicle. Often, a brake controller wiring harness is included with your tow package. This harness plugs into a port beneath your dash and connects to the four wires of the brake controller. If you do not have a harness, or you need a new one, the Tow Ready wiring adapter will serve the same purpose.
2005 - 2007 Ford F-250 and F-350 Super Duty with factory 4-Flat
2005 - 2007 Ford F-350, 450, and 550 Cab and Chassis with factory 4-Flat
2005 - 2007 Ford F-250 and F-350 Super Duty with factory 7-Way
2005 - 2007 Ford F-350, 450, and 550 Cab and Chassis with factory 7-Way
Customers Who Purchased This Accessories and Parts Also Bought...
Ask the Experts about this Draw-Tite Accessories and Parts
Do you have a question about this Accessories and Parts?
Installation Details
