bing tracking image

Best Nissan Xterra Ski and Snowboard Racks

change vehicle


Ski and Snowboard Racks Videos

Thule Tram Ski and Snowboard Carrier Adapter Review - 2013 Nissan Xterra

Today on our 2013 Nissan Xterra, we will be test fitting the Thule Tram Ski and Snowboard Carrier Adapter for Hitch-Mounted Bike Racks, part number TH9033. With our bike carrier already installed onto our vehicle, we will begin by opening the back two cradle straps. Then we will place the Thule Tram on top of our bike carrier. We will secure it by tightening down each cradle strap. We will run the bolts through the clamp on the backside of the mast and secure it by tightening down the wing nuts. To load our snowboard and skis, we will push the oversized grey buttons on the outside of the carrier to open up our jaws.



Yakima FatCat Ski and Snowboard Carrier Review - 2012 Nissan Xterra

Today on our 2012 Nissan Xterra, well be test fitting the Yakima FatCat 6 Locking Rooftop Ski and Snowboard Carrier with a 6 ski or 4 board capacity, part number Y03088. With the Yakima round bar roof rack system on our vehicle, well begin our test fit by placing half of our carrier on to our front crossbar. Well bring the strap around fitting the back into the front of the carrier. Then we can lift up the buckle and clamp it down. Well open up our jaws to gain access to the thumb tabs on the inside. Here on the passenger side, well flip it up, tighten it down and unflip it back down.



Whispbar Roof Ski and Snowboard Carrier Review - 2012 Nissan Xterra

Today, on our 2012 Nissan Xterra, we'll be test fitting the Whispbar locking roof top ski and snowboard carrier with a six ski or four board capacity, part number WB-300. With the Yakima Round Bar roof rack system on our vehicle, we'll begin by placing half of our carrier onto our front cross bar. Here on the passenger side, we'll bring the rubber coated strap around our cross bar, fitting it back into the foot of the carrier. We can enclose down the buckle and push the over sized button on the end of the carrier to open up our jaw. We'll then flip up our thumb tab, tighten it, and push it back down. We can then move to the other side and repeat the same process. We'll grab the other half of our carrier and place it onto our rear bar. Before we secure it, we need to make sure that it's in line with the front half. Once we have it in line, we can bring the strap around our bar fitting it back into the foot of our carrier, close the buckle, open our jaw, and tighten down our thumb tab. We'll then repeat that process for the other side. With our jaws open, we'll grab our snowboard and place it into our carrier, followed by our skis.