# 1
Draw-Tite Ball Mount for 2" Hitches - 2-3/4" Rise, 4" Drop - 9" Long - 7.5K
Working in the sand and grass of my driveway my wife and I installed our new etrailer receiver hitch. Great fit and finish! Went right on as described in the online guide. Hitch required a spacer washer on top back bolt attachment point. Taped it on so it would not move while lifting in place and it stayed right there! Used a car jack to raise up and hold the hitch into the underside of the trunk tighten the bolts and reattached the tail pipe done. Now we can pull our Sunfish Sailboat any where the car will go.
I am very pleased with the hitch, ball mount, and electrical package. All were easy to install if you follow the easy to understand directions. An added plus for putting one of these on a MINI is that the hitch can be hidden behind the "black plate/cover" that is on the rear bumper. It looks just like it came out of the factory except when to need to install the ball mount. The service has been outstanding. This is the place to go.
# 2
etrailer Ball Mount Kit - 3" Rise or 4" Drop - 16,000 lbs
This was a combination product that contains both trailer balls that I use. I am very pleased with the product and do not have to worry about it breaking under a heavy pull. The service was great including the delivery time frame. I am a completely satisfied customer and will do repeat business in the future! I got all of this for what most companies would charge for 1 ball and 1 hitch bar! Great Value!!!
This was what I needed as far as a high capacity (16k lb) ball mount with the right amount of drop, but the mount does not fit "snugly" in my receiver. There is a bit of play between the receiver and the mount when it is installed.
# 3
B&W Tow & Stow Pintle Hook with 2-5/16" Ball - 2" Hitches - 10,000 lbs/16,000 lbs
Works great! I use this hitch on a regular basis utilizing the ball on one use and pintle on the other. I often drive over rough terrain pulling a Tucker Terra Sno-Cat or a 50kW genset, this hitch handles the roughness. The universal hitch is optimum when hauling via pintle or ball.
It works good but to me it wears a little too much from the movement of the Pintle on the flat section where the pintle sits on the hitch
# 4
Draw-Tite Ball Mount for 2" Hitches - 3" Rise, 4" Drop - 9-1/4" Long - 16K
Perfectly as described, Box was a heavy hitch and the box must have been damaged in shipping so it was a little delayed. You can't mess up a forged hitch it still is in excellent condition.
This simple ball mount will get the job done. It's a solid casting so it weighs a lot.
# 5
Convert-A-Ball Ball Mount for 2" Hitches - 2-3/4" Rise, 4" Drop - 10,000 lbs
Good, very solid ball mount with just the extra rise I needed, 2 3/4", to get level trailer and good clearance for the trailer jack. But excessive shipping charges from etrailer, $[XX] for an $[XX] purchase. Found out to my cost later that [online vendor] would have shipped for free.
As a full-time RVer, e-shopping is very important for us. etrailer was the right place to shop. Right product, delivered on-time for a great price. You beat the local discount RV store by $25 including shipping. At the same time, I had another outfit send me a clearly inferior product to the one they displayed. Said they would e-mail a pre-paid shipping label for the return (didn't) and tried to put the blame on Amazon. Thanks etrailer for a great experience !
What our customers are saying:
"I like the easy of navigation through the site. It only took me a couple of minutes to place my order. Thank You I will shop this sight again in the future."