Brake Controller Wiring Adapter for Jeep Grand Cherokee

Tow Ready Accessories and Parts - 22294

The brake control wiring adapter is used to simplify the electric brake controller installation. The four wires on the adapter are butt-connected to the four wires coming out of the electric brake controller. The harness is then plugged in to a port under the dash. All the wires for the brake controller have already been run from the 7-way trailer connector in the back of the vehicle to that plug.

• Fits:
  • 2011 Dodge Durango w/Factory Tow Package
  • 2011 Jeep Grand Cherokee w/Factory Tow Package

Tech Tip: The vehicle plug is located to the right of the steering column behind the black pocket in the dash.

22294 Tow Ready Brake Controller Adapter

Customers compare 22294 to these similar products

Universal Installation Kit forTrailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires$64.80

Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers$15.95

Wiring Kit for 2 and 4 Brake Electric Brake Controllers$37.26

Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers - Dodge$14.99

Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers - Dodge$15.95

Customers who look at this part also view

T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector$25.95

Customers Who Purchased This Accessories and Parts Also Bought...

Jacketed 2 Wire, 10 Gauge, Brake Wire - per Foot $1.21

Lockwasher for Brake Mounting Bolt for 7" and 10" Brake Assemblies $0.15

Nut for Brake Mounting Bolt for 7" and 10" Brake Assemblies $0.25

Ask the Experts about this Tow Ready Accessories and Parts
Do you have a question about this Accessories and Parts?

• Parts Needed to Install a Trailer Brake Controller on a 2007 Jeep Grand Cherokee
  
• There are 2 different wiring configurations on the 2007 Jeep Grand Cherokee. If it has a factory installed 7-Way some models will require a wiring kit to run to the battery. You can use # 5505 with a 20 amp circuit breaker, or # 5506 for a 30 amp circuit breaker. The 20 amp is good for 2 to 4 brakes and the 30 amp is good for 6 to 8 brakes. This also means that you will need to route a wire from the controller blue wire back to the back of the 7-Way connector and attach it to the 7:00 positio
  view full answer...