Self Tapping Screw for Sway Control Ball Plate Assembly

Draw-Tite Accessories and Parts - 3403

• Qty 1
• Need 6 to attach ball plate assembly
• 24-9 X 1" Screw

Customers compare 3403 to these similar products

Replacement Ball-Plate Assembly for Reese Friction Sway-Control System$31.95

Reese Sway-Control Bracket for 2" Ball Mounts - Class III and IV$29.95

Replacement Lift Brackets with Handle for Reese Weight Distribution Systems$77.95

Customers who look at this part also view

Friction Sway Control$128.95

Customers Who Purchased This Accessories and Parts Also Bought...

Replacement Lift Brackets with Handle for Reese Weight Distribution Systems $77.95

Bonded 4 Wire - per foot $0.57

3M SCOTCHLOK Quick Splice Wire Connector - Blue Gel - 14-18 AWG (Qty 1) $0.65

Sealed, Uni-Lite Mini LED Side Marker and Clearance Light w Grommet, 2 wire, 2 Diode - Amber $5.50

Mounting Hardware and Snap Caps for DWD License Plates and License Plate Frames - Black $3.49

Ask the Experts about this Draw-Tite Accessories and Parts
Do you have a question about this Accessories and Parts?

• Installation of Self Tapping Screw and Spring Clig for Reese 3400 Sway Control
  
• To in stall the Self Tapping Screw for Sway Control Ball Plate Assembly, item # 3403, you will need to make the proper measurement for your sway control bar and drill holes, either 9/32 or 11/32 inch depending on your trailer tongue, then install the screws through the ball plate mounting assembly, item # 3473, if you need one. The Spring Clip for Sway Control, item # 2867, secures the sway control assembly ball sockets to the sway control balls through holes in the side of the ball sockets.
  view full answer...