2010 Infiniti Accessories:

Select Model for Your 2010 Infiniti

2010 Infiniti Accessories

Towing

2010 Infiniti Trailer Hitch

2010 Infiniti Trailer Wiring

2010 Infiniti Brake Controller

2010 Infiniti Base Plate for Tow Bar

Cargo Control

2010 Infiniti Roof Rack

2010 Infiniti Trunk Bike Rack

Performance Accessories

2010 Infiniti Cold Air Intake

2010 Infiniti Air Filter

2010 Infiniti Exhaust

2010 Infiniti Suspension Enhancement

2010 Infiniti Performance Chip

2010 Infiniti Interior Lights

2010 Infiniti Exterior Lights

2010 Infiniti Tire Chains

2010 Infiniti Throttle Body Spacer

Vehicle Trim

2010 Infiniti Floor Mats

2010 Infiniti Tube Steps

2010 Infiniti Vehicle Covers

2010 Infiniti Side Window Vents

2010 Infiniti Lamp Guards

2010 Infiniti Vehicle Tent

2010 Infiniti Vehicle Seat Covers

2010 Infiniti Windshield Wiper Blades

2010 Infiniti Questions and Answers

• Will the Thule Boxter Cargo Box fit the Factory Roof Rack on a 2010 Infiniti QX56
  
• The Thule Boxter, # TH611, does fit the factory roof rack on a 2010 Infiniti QX56. However, with the box installed there will be rear hatch interference. You will not be able to fully open the rear hatch without making contact with the box. The largest box that will fit your factory roof rack and allow the rear hatch to fully open is the Atlantis 1600, # TH686BXT for black or # TH686XT for silver. You will not need any additional accessories to attach any of the above boxes to the vehicle
  view full answer...


• Boat Trailer Towed by 2010 Infiniti QX56 Rocks Back and Forth when Driving on Rough Roads
  
• My first thought is that perhaps the boat is not fully secured to the trailer and that is causing some movement. You will also want to look at the trailer tires and suspension for wear. Replace any worn out parts and make sure everything is tight light it should be. The trailer tires should be inflated to the maximum psi rating as indicated on the tire sidewalls. You mentioned that the surge coupler is working properly but it would be worth it to examine the shock to determine if it need
  view full answer...


• Will the Thule Atlantis 2100 XT Cargo Box Fit on a 2010 Infiniti QX56 with Factory Crossbars
  
• Thule has determined that the Atlantis 2100 XT Cargo Box, # TH688XT, will fit on the factory crossbars on your 2010 Infiniti QX56. I did some research on your vehicle and found that the roof weight capacity is 200 lbs, however, this cargo box has a weight capacity of 110 lbs. You should not exceed the weight capacity of the cargo box. If the crossbars on your vehicle are adjustable, then I would recommend mounting this cargo box with the widest spread possible. This will provide more stabil
  view full answer...


• Can 3 Bikes Be Used on a Class I Hitch if the Weight is Less than the Tongue Weight Rating of Hitch
  
• As long as you do not exceed the tongue weight capacity listed by the hitch manufacturer, the tongue weight capacity listed in the owners manual of your 2010 Infiniti EX35, and never put more than two bikes on the rack you would be fine. The reason you could not put three bikes on this rack even if the total weight was less than the tongue weight capacity is because of the distance of the weight of the third bike away from the hitch opening. The further the weight is away from the hitch the m
  view full answer...


• How Visible is the Curt Class III Hitch # 13354 when installed on a 2010 Infiniti FX35
  
• My technical contact at Curt Mfg. was kind enough to send me a photo of the Curt Class III Round Tube Receiver Hitch, # 13554, on an Infiniti FX35. I attached this photo for you to see. The hitch in the photo is blue because it is the engineering mockup for the hitch, but it does show the final position of the hitch when correctly installed. The hitch in black will blend much better with the vehicle underbody. None of the hitches we carry for the 2010 Infiniti FX35 will be completely invis
  view full answer...


• Availability of Trunk Mount Bike Rack For 2010 Infiniti FX35
  
• I do have a trunk bike rack that will fit your 2010 Infiniti FX35, but it will not be the Yakima KingJoe Pro 3 Bike Rack, part # Y02625. Yakima does not have a trunk bike rack to fit the Infiniti FX35 because the side strap hooks on the bike rack cannot be securely attached. I would recommend the Thule Raceway 3 Bike rack, part # TH9002, for your FX35. The Raceway is the easiest to install and remove bike rack I have ever seen. It uses retractable cables instead of straps to secure the rack t
  view full answer...


• Trunk Mounted Bike Rack Recommendations for 2010 Infiniti G37 Coupe
  
• Yakima does not recommend using any of their trunk mounted bike rack on your vehicle because the vehicle is unable to support the weight at the point where the carrier must be placed. Thule states that three of their racks, the Archway part # TH9009XT, the Gateway part # TH9006XT and the Passage part # TH910XT will work well with your vehicle. The Gateway would be a good choice, it features padded anti-sway cradles that will keep your bikes safe and secure. For womens bikes or bikes with s
  view full answer...


• Bike Rack Recommendation for a 2010 Infiniti G37 Convertible
  
• I have a solution for you, but I checked with our bike rack manufacturers and none of them have any trunk mounted bike rack options for your 2010 Infiniti G37 convertible. The best option for you would be to put a hitch on the back of your vehicle and then use a hitch mounted bike rack. For a hitch I would recommend a Curt Trailer Hitch # C11068. I attached installation instructions for this product for you to check out also. For a bike rack I would recommend a Thule Vertex 2 Bike Carrier
  view full answer...


• Recommend a Trailer Hitch to Carry Bike Rack For 2010 Infiniti G37 Convertible
  
• We do have a trailer hitch available that will fit your 2010 Infiniti G37 Convertible, you will need the CURT Trailer Hitch, part # C11068. The CURT # C11068 is a Class I 1-1/4 inch hitch, you will need to make sure your bike rack is compatible with Class I hitches. Installation of the CURT # C11068 requires drilling, and minor trimming of the rear bumper fascia. The estimated installation time is approximately 3 hours. I have linked instructions for you to view. The instructions include pict
  view full answer...


• Receiver Location for a CURT Trailer Hitch on a 2010 Infiniti G37
  
• I have included a link to the installation instructions for the CURT Trailer Hitch, # 11499, for your 2010 Infiniti G37. The hitch touching the vehicle is not really an issue because you will actually have to trim some of the rear fascia to allow the hitch to fit as noted in the instructions. The warning you are referring to for non-trailer loads is only on certain CURT hitches. More specifically, it is referring to all CURT Class I, Class II, and some Class III trailer hitches. This is a req
  view full answer...


• Availability of Roof Cargo Bag For a 2010 Infiniti QX56
  
• Anytime you are going to haul cargo on the roof of your 2010 Infiniti QX56 ( I do not list a Q54 model) you will want to check the owners manual or with the Infiniti dealer for what the roof capacity is for your vehicle. The roof capacity will let you know how many pounds you will be able to haul on the roof of your vehicle. The Thule Tahoe Expandable Roof Rack Cargo Bag, part # TH867 is designed to work on your factory roof rack if you have crossbars that run from side-to-side. If you have t
  view full answer...


• Which is the Smallest Roof Mounted Cargo Box that will Fit 2010 Infinit EX35 with Factory Crossbars
  
• The Yakima Rocket Box Pro 14 needs a cross bar spread between 24 and 36 inches, so if your cross bars are not adjustable, you will not be able to use this box. According to the Yakima Fit Guide, it will fit, so that tells me that you probably have adjustable cross bars. However, auto manufacturers are known to do odd things, so I would double check. The Rocket Box Pro 14 is the smallest box Yakima produces that they list as a fit for your vehicle. Thule offers quite a few, the smallest
  view full answer...


• Installation of DrawTite #75657 on 2010 Infiniti FX35
  
• To install the Draw-Tite Class III receiver hitch part # 75657 on your Infiniti, the splash guards, under body appearance panels and tow hook will need to be removed. Once the installation is completed, the splash guards will be replaced, but the tow hook and the under body panels will not be re installed as they would interfere with the hitch. If you choose to install the hitch, we recommend keeping these removed items in the event you should decide to remove the hitch in the future. For you
  view full answer...