2010 Audi Accessories:

Select Model for Your 2010 Audi

2010 Audi Accessories

Towing

2010 Audi Trailer Hitch

2010 Audi Trailer Wiring

2010 Audi Brake Controller

Cargo Control

2010 Audi Roof Rack

2010 Audi Trunk Bike Rack

Performance Accessories

2010 Audi Cold Air Intake

2010 Audi Air Filter

2010 Audi Exhaust

2010 Audi Suspension Enhancement

2010 Audi Performance Chip

2010 Audi Interior Lights

2010 Audi Exterior Lights

2010 Audi Tire Chains

Vehicle Trim

2010 Audi Floor Mats

2010 Audi Vehicle Covers

2010 Audi Side Window Vents

2010 Audi Lamp Guards

2010 Audi Vehicle Tent

2010 Audi Vehicle Seat Covers

2010 Audi Windshield Wiper Blades

2010 Audi Questions and Answers

• Comparison Between Curt Tail Light Kit # 56146KIT and Tow Ready 4 Pole Harness # 119179KIT
  
• The Tow Ready 4 Pole Harness # 119179KIT you referenced is a compatible fit for your 2010 Audi A3; however, the Curt Tail Light Kit # 56146KIT is not. Another trailer wiring kit that will work for your vehicle is the Hopkins Active Tail Light Converter # 46255. Both kits are similar in that they are universal fit with powered converters, come with install kits, and are very close in price. The Tow Ready kit comes with a circuit tester, (5) quick splice wiring adapters, and has a slightly high
  view full answer...


• Snow Tire Chains for a 2010 Audi Q7 with 295/35-21 Tires
  
• You will need to consult the vehicle owners manual to determine if tire chains can be used and if they can if there are any restrictions. If the tires are not the factory size then you will also want to contact an Audi dealer to determine if chains can be used. If they can then the only chains we have for a 295/35-21 tire are the K-Summit chains you have referenced, # TH02230K66. These chains require zero millimeters of clearance on the back side of the tires. I have included some tire chains
  view full answer...


• Hitch Recommendations for 2010 Audi A6
  
• If you click on the link I have provided, you can see the available hitches for your 2010 Audi A6. As you can see, all the hitches are almost identical in appearance. They have the same weight bearing capacities and would install in the same manner. None of the hitches would be any more or less visible from the rear than any of the others. I would recommend the Draw-Tite Class I, part # 24836. Since the hitches are so similar, you would not sacrifice anything to going with a less expensive op
  view full answer...


• Any Extra Parts Needed For Thule Passage 2 Bike Rack # TH910XT To Carry Womans Bike on 2010 Audi A4
  
• The Thule Passage 2 Bike Rack, part # TH910XT, is a good fit for your 2010 Audi A4. I am including links to the installation instructions and a video review on the #TH910XT bike rack. The part you might need for the womans bike is the Thule Bike Adapter Bar, part # TH982XT. This adapter bar attaches to your bikes seat post and handlebar stem post, providing a horizontal bar for the bike rack to grab on to. It will help keep the bike level for safe transport. It would be required if there is n
  view full answer...


• Thule Vertex Bike Rack Recommendation for Carrying 2 Bikes on a 2010 Audi Q5
  
• I have a solution that will allow you to carry 2 bikes on your 2010 Audi Q5, but there are not any trunk mounted bike racks that are confirmed fits for your vehicle. I checked and it looks like the attachment point for the top straps would not work In order to carry bikes at the rear of your bike you are first going to need a hitch. For that I recommend you get a Draw-Tite Trailer Hitch # 75708. Once installed you would be ready to mount a bike rack on the hitch of your vehicle. For a bik
  view full answer...


• Trailer Hitch and Bike Rack Recommendations for a 2010 Audi A4 Sedan
  
• The CURT Class I, II, and some Class III trailer hitches require the use of a stabilizer strap, # 18050, in order to be in compliance with CURTs warranty requirements. The strap is meant to relieve some of the stress from the hitch when used for any non-trailer load such as a bike rack or cargo carrier. Other manufacturers do not require a strap. For your 2010 Audi A4, I recommend the Draw-Tite Trailer Hitch, # 24830. This is the most popular hitch for your vehicle. I have included a link to
  view full answer...


• Installation Instructions for Installing a Draw-Tite Trailer Hitch # 75708 on a 2010 Audi Q5
  
• To install this Draw-Tite Max-Frame Trailer Hitch, part # 75708, onto your 2010 Audi Q5 you will need to follow the steps below that I took from the installation instructions for this product. I also attached the installation instructions for you to check out. 1. Raise vehicle on hoist or ramps. Use appropriate safety precautions. 2. Remove lower fascia by removing two screws to the trunk and a screw in each wheel well with a T-20 Torx bit. There is a snap in tab next to the wheel well scr
  view full answer...


• How Similar is the Draw-Tite Hitch # 75708 to the Hidden Hitch # 87603
  
• This Hidden Hitch Trailer Hitch, part # 87603, and the Draw-Tite Hitch, part # 75708, are so similar that they share the same installation instructions as well as the same recommended ball mount, pin and clip. I have attached instructions for you to check out. The recommended ball mount is the Ball Mount 3/4 inch Rise or 2 inch Drop, part # 2923. The recommended pin and clip is the Pin and Clip, part # PC3. The recommended wiring is the Curt Wiring for the 2010 Audi Q5, part # 56200. In
  view full answer...


• Compatibility of Curt Class I Receiver Part # 11186 with 2010 Audi A4 Avant
  
• I have spoken with one of my contacts in Tech Support at Curt Manufacturing, who tells me that the the Class I Receiver Hitch, part # 11186 will not fit the wagon, or Avant model. He confirmed that the receiver you currently have is the only receiver designed for use on that vehicle.
  view full answer...


• What is the Diameter of the Replacement U-Bolt # 43216 and the Length of the Threaded Section
  
• The distance from the bottom of the curve to the tip of the bolt is about 3-3/16 inches, and the diameter of the bolt is 5/16 of an inch.
  view full answer...


• Comparison Between Curt Trailer Hitch # C13057 and Hidden Hitch # 87603 for a 2010 Audi Q5
  
• The Hidden Hitch Trailer Hitch, # 87603, for the 2010 Audi Q5, when installed will have the same appearance as the Curt hitch, # C13057. The receiver will be visible on either hitch along with some of the cross tubing. However, I would not say that it is obtrusive or looks bad. In terms of quality, hitch 87603 complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and SAE J684 which are the standards hit
  view full answer...


• Is Trailer Hitch # 11195 Visible When Installed on a 2010 Audi a4 Avant
  
• The available trailer hitch for the Avant model of the 2010 Audi a4 is Curt Trailer Hitch, # 11195. This hitch comes with the recommended drawbar. The cross tubing will be visible under the bottom bumper. Because of where the attachment points are on the vehicle, the hitch will be visible. I have included a link to the installation instructions below. With this hitch installed, you will just need a hitch ball and wiring for the trailer. For a ball, you can use # 19256 (1-7/8 inch diameter) or
  view full answer...


• Will the Draw-Tite Class I Trailer Hitch # 24830 Fit on a 2010 Audi A4 Avant
  
• We have a hitch that will fit the Audi A4 Avant Wagon, Including Quattro models. The Curt Class I Trailer Hitch Receiver with Drawbar, item # 11195, is the correct hitch for your vehicle, and I have included instructions for you to review. The Draw-Tite Class I Trailer Hitch Receiver, item # 24830, you have referenced is not designed to fit the Audi A4 Avant. It will only fit the sedan model. Some items you may also need to complete your towing setup are listed below. Hitch Ball 1-7/8 i
  view full answer...


• Difficulty of Installing the Curt Class III Trailer Hitch Receiver, # 13220 on a 2010 Audi Q7
  
• I was an English and Literature professor a few years back so I know that academia can produce modern day renaissance men and women capable of installing a trailer hitch. With that said, the instructions state that the estimated install time for the Curt Class III Trailer Hitch Receiver, # 13220, is 3 hours (90 minutes for a pro). We have a scale of difficulty for installing trailer hitches. It is a 10-based scale with 1 being equivalent to attaching two legos together and 10 being quantum m
  view full answer...


• Wiring Harness Installation Instructions and Functions for a 2010 Audi Q5 With Tow Package
  
• The aftermarket wiring harness for the 2010 Audi Q5 is the CURT Wiring Harness, # 56200 and installation kit # 55151. It includes a powered converter that receives power directly from the battery and reduces the draw on your vehicles sensitive circuitry and taillight wiring. There may be a factory 4-way connection at the rear of the vehicle but there is not currently an OEM version available. You need to consult your local dealer. Installation of the harness is fairly simple. I will outline
  view full answer...